SX-2000 Light
Remote Maintenance Setup

Modem to Switch Cabling

Modem DB25 Pin # Switch DB9 Pin # 2 Transmit 2 3 Receive 3 4 Request to Send 7 5 Clear to Send 8 6 Data Set Ready 6 7 Signal Ground 5 8 Sig. Detect 1 20 Data Terminal Ready 4

33.6 Robotics Sportster / Fax Modem
(8 Dip Switch Settings)

1 down Data Terminal Ready Override 2 up Verbal Result Codes 3 up Suppress Result Codes 4 down No Echo Offline Codes 5 up Auto Answer 1st Ring 6 up Carrier Detect Normal 7 down Load Factory Defaults 8 down Smart Mode

Remote Laptop Parameters

Port Speed : 9600 Data Bits: 8 Data Protocol: Standard EC Parity: None Compression: Enabled Stop Bits: 1 Flow Control: Xon/Xoff Modulation: Standard Emulation: VT 100 ASCII Setup

Notes:

• The remote maintenance modem can be connected to any peripheral node remote maintenance port (J6, J7, J10).
• In order for a Technician to log in remotely, the maintenance terminal must turned on (not logged in) and set to the active plane.
  

---