VGMC Password Reset
Procedure to reset the VGMC login and password to 'itgadmin', you can then use the setLeader
command to set the IP Address:
- Connect a terminal to the Maintenance port, either directly (female DIN-8, labeled Maint),
or via the I/O panel (DB-9 male). The terminal communication parameters must be as follows:
9600 baud, 8 data bits, no parity, 1 stop bit
- Press the Enter key on the keyboard.
The
IPL>
prompt is displayed. - Reboot the card by pressing the RESET button on the faceplate of the card with a pointed object, such as a ball-point pen.
- Start up messages are displayed on the terminal. Type
jkl
on the terminal keyboard when the prompt is displayed.Note: jkl runs from BIOS or boot ROM which is printed early in the bootup process. There is only a six second window at the prompt to enter jkl. If the prompt is missed, restart the card and repeat the above step.
- Once the card has booted from BIOS or boot ROM, a CLI prompt (such as the
BIOS>
) appears.Enter the following command:
shellPasswordNvramClear
at the CLI prompt. - Type
reboot
at the prompt to reboot the card.