Option 11 E&M Trunk Card
Configuration Example

Introduction

The following configuration example will show you how to configure the Nortel PBX Option 11 E&M Trunk Card. This configuration will allow you to connect this card to a Cisco E&M voice port.  

Hardware and Software Versions

To implement this configuration, you need the following:

Configuration

In the following configuration, notes about the configuration are in bold italics. The <RET> throughout the cofiguration indicates that you need to hit the return key after the respective command parameter.

#ADDING E&M CARD: (BUILDING ROUTE DATA BLOCK. USE DOUBLE DIGITS W/ ROUTE DATA BLOCK.)
LD16(LOAD 16)
REQ:NEW
TYPE:RDB
CUST:0
DMOD:<RET>
ROUT:21
TKTP:TIE
ESN:<RET>
(ALL RETURNS UNTIL ICOG PROMPT)
ICOG:IAO (INCOMING, OUTGOING)
SRCH:<RET>
TRMB:<RET>
STEP:<RET>
ACOD:71
TARG:0 (TGAR 0 AND ENDCOST 0)
BILN:<RET>
(ALL RETURNS UNTIL CNTL PROMPT)
CNTL:YES
TIMR:<RET>
SST:<RET>
NEDC:ETH(NEAR END DISCONNECT SET FOR EITHER)
FEDC:ETH(FAR END DISCONNECT SET FOR EITHER)
CPDC:<RET>
(ALL RETURNS UNTIL ALRM)
<SHIFT>****
LD21(LOAD 21 TO VIEW RDB)
REQ:PRT
TYPE:RDB
CUST:0
ROUT:21
<SHIFT>********
(IF YOU NEED TO CHANGE FROM 2 WIRE TO 4 WIRE CABLES OR VICE VERSA, ALSO
CHANGE IN PBX CONFIG)
LD14(LOAD 14 TO ADD NEW TRUNK)
REQ:NEW
TYPE:TIE
TN:9 0(ANALOG STARTS AT 0 DIGITAL STARTS AT 1)
XTRK:XEM
CUST:0
NCOS:0
RTMB:21 1
MNDN:<RET>
TGAR:0
SIGL<RET>
EMTY:TY1(DEPENDS ON CABLING)
CPAD:<RET>
STRI:IMM
STR0:IMM
SUPN:<RET>
CLS:UNR DTN(CLASS OF SERVICE)
TKID:<RET>
<SHIFT>********
VIEW TRUNK.
LD20(LOAD 20)
REQ: PRT
TYPE: TRK
TN: 9 0
RTMB: (All returns until the end)
<SHIFT>********
AFTER FINISHING ALL 4 TRUNKS YOU MUST ENABLE THE TRUNKS.
LD32
STAT 9
DISC 9(DISABLE CARD 9:THE E&M CARD)
ENLC 9(ENABLE CARD 9)
<SHIFT>********
TO MODIFY E&M TYPE, OPERATION(2 OR 4-WIRES) AND SIGNALLING.
LD14(LOAD 14 TO ADD NEW TRUNK)
REQ:CHG
TYPE:TIE
TN:9 0(ANALOG STARTS AT 0 DIGITAL STARTS AT 1)
XTRK:XEM
CUST:0
NCOS:0
RTMB:21 1
MNDN:<RET>
TGAR:0
SIGL<EM4> (EM4 FOR 4-WIRES, EAM FOR 2-WIRES)
EMTY:TY2 (E&M TYPE 2 DEPENDS ON CABLING)
CPAD:<RET>
STRI:WNK
STR0:WNK
SUPN:<RET>
CLS:UNR DTN(CLASS OF SERVICE)
TKID:<RET>
<SHIFT>********

tumblr page counter